Dealectric

Which portable power station can act as a UPS for a NAS and signal it to shut down over USB? (2026)

Updated 2026-11-12 · Pick: EcoFlow RIVER 3 Plus, on EcoFlow's site: https://www.ecoflow.com/us/river-3-plus-portable-power-station

Short answer. The EcoFlow RIVER 3 Plus is the portable power station that can be a UPS for a NAS and send a USB shutdown signal: its USB-B port feeds EcoFlow Power Manager, whose only supported model it is. Its AC stays live 60+ seconds after the NAS shuts down, so the NAS won't restart alone.

Searched as: portable power station USB HID UPS communication NAS shutdown NUT supported models 2026EcoFlow Delta USB HID UPS NAS shutdown USB data port

How this table was made: each figure comes from the maker's own US product page or manual, or from the reviewer named next to it, checked 2026-11-08. Dealectric does not test units itself. Rows with a Buy link are products Dealectric lists: the links are affiliate links, and their codes are re-tested in the brand's own cart every day (last check 2026-11-13).

ModelUSB shutdown signalWhat runs the shutdownAfter the NAS shuts downBatterySwitchoverPriceBuy
EcoFlow RIVER 3 PlusYes: USB-B port to a PC or NAS (EcoFlow)EcoFlow Power Manager, which lists it as its only supported device; or NUT 2.8.3+ usbhid-upsAC stays live 60+ s; “Shutdown does nothing” (NUT #2735), so the NAS stays off if mains returns before the battery runs out286 Wh, 10.4 lb9 ms (StorageReview)No price on EcoFlow's US store (2026-11-08)EcoFlow's page
EcoFlow DELTA 3 PlusYes: USB-C, usbhid-ups, NUT support level 3NUT 2.8.3 or later only; not on Power Manager's listSame EcoFlow HID driver (“almost identical”, NUT #2735): no command to switch its AC off and back on1,024 Wh; 910 Wh delivered (StorageReview)Just over 8 ms (StorageReview)$719 on Amazon (checked 2026-11-12)Buy on Amazon
UGREEN NAS UPS US3000Yes: USB cable to a UGREEN NAS (NASCompares)UGOS Pro's built-in UPS client; UGREEN NAS models with external DC input onlyRestarted the NAS when power returned (NASCompares test)43.2 Wh (12,000 mAh), 120 W DCInstant in NASCompares' test (0 s spec)$109.99 on ai.ugreen.com, 2026-11-03Buy
EcoFlow DELTA 3 UltraYes: USB 2.0 data over the USB-C 140 W output port (EcoFlow)The NAS's own UPS client, per EcoFlow; not in NUT's hardware listEcoFlow's setup steps end at the NAS's UPS settings and name no control to switch the AC off and back on3,072 Wh, 32.7 kgUnder 10 ms rated (EcoFlow)$1,299 (maker, 2026-11-08)EcoFlow's page
Anker SOLIX C1000 Gen 2No: “There's no data port” (ComputingForGeeks)Nothing; the NAS runs until the battery is emptyNo shutdown signal, so the NAS loses power without warning when the battery runs out1,024 Wh (ComputingForGeeks)Under 10 ms rated by Anker (ComputingForGeeks)$529.99 on Amazon (checked 2026-11-12)Buy on Amazon
BLUETTI AC180No: no data port on BLUETTI stations (ComputingForGeeks)Nothing; the NAS runs until the battery is emptyNo shutdown signal, so the NAS loses power without warning when the battery runs out1,152 Wh (ComputingForGeeks)20 ms or less rated, with Grid Enhancement off (ComputingForGeeks)$499 on bluettipower.com, 2026-11-07$474.05 through this link
Lowest price checked 2026-11-13; discount applied in the cart (tested 2026-11-13); bluettipower.com without the link $499

What the differences mean

The runtimes below assume a 30 W NAS. Apollomaniacs measured a 2-bay QNAP TS-269L v2 at 27 to 31 W. They leave out the station's own standby draw, so treat them as ceilings.

Your NAS and needFits
UGREEN NAS with DC input: clean shutdown and automatic restartUGREEN US3000
TrueNAS, Unraid, Proxmox or Linux, where you can run NUT 2.8.3 or later; many hours of runtimeEcoFlow DELTA 3 Plus
Windows PC plus NAS for a few hours, with EcoFlow's own softwareEcoFlow RIVER 3 Plus
Two days or more on one chargeEcoFlow DELTA 3 Ultra
Synology or QNAP on stock firmware, no scripts, must restart by itselfA conventional USB HID UPS (APC Back-UPS class), not a power station

Why the NAS shuts down but doesn't come back on

A conventional UPS handles an outage in two steps. First the NAS shuts down, then the UPS switches its outlets off and back on. The Network UPS Tools manual explains why: “the UPS load should be turned off so that all devices that are attached to it are forcibly rebooted”, and “If your UPS just sits there and never resets the load, you are vulnerable to a power race”. An APC Back-UPS ES 650G2 gives NUT the commands for the second step: load.off, load.off.delay and shutdown.reboot.

The EcoFlow stations only do the first step. In NUT issue #2735 the RIVER 3 Plus offers only driver commands: driver.killpower and the three driver.reload variants. On 2026-10-29 an owner running firmware V1.33.81.61 with NUT 2.8.4 reported that the low-battery shutdown ran, but “Shutdown does nothing” and “the AC output stays live for 60+ seconds afterwards”. The same thread calls the DELTA 3 Plus “almost identical”. The issue is still open, with its milestone set to NUT 2.8.6. If mains power returns before the battery runs out, the NAS never loses power, so its “power on when power returns” setting never triggers and it stays off until someone presses the button. If you need to reach the NAS remotely, plan a way to power it on remotely, or use a UPS that resets its outlets.

How the signal reaches the NAS differs by model:

Not recommended

BLUETTI AC180 and Anker SOLIX C1000 Gen 2 for this job. Both can keep a NAS running through a brief outage: Anker rates the C1000 Gen 2 under 10 ms, and BLUETTI rates the AC180 at 20 ms or less with Grid Enhancement off. But ComputingForGeeks lists no data port for either brand's stations, so nothing tells the NAS to shut down, and it loses power without warning when the battery runs out.

Sources

Published 2026-11-04; updated 2026-11-12. The buy links are affiliate links; see the disclosure. Corrections welcome at [email protected] or /feedback.